Putting the finishing touches on a red oak panel
-
Rcnewcomb
- Vectric Archimage
- Posts: 5927
- Joined: Fri Nov 04, 2005 5:54 am
- Model of CNC Machine: 24x36 GCnC/WinCNC with ATC
- Location: San Jose, California, USA
- Contact:
Putting the finishing touches on a red oak panel
My feedrate was 2ips on a Shopbot PRT Alpha. The "fuzzies" were due to a slightly dull bit. I was able to clean them up by hand in under 5 minues. I v-carved this piece of red oak with a 0.5" V60 bit from CMT (3 flutes). The flat area was cleared down to a maximum of 1/8 inch with a 0.125" downspiral bit from Onsrud.