I Guess just about everything
Was the texture pattern in the panel done with fluting and you repeated curves until you got a pleasing pattern in preview? I see how you did relief for the stiles on top-Nice. On that lip on the bottom are there elliptical pockets on that ledge, or just a sloping surface for elbows or aesthetics?
Cutting a sloping surface right now as a pocket for business cards with a .75 bowl bit(tried 1/4down,1/2up,1/2straight yesterday) and was going nuts trying to get the cut time practical and kept getting lines even with .04" line spacing(pain to sand pockets that small in production mode), and THEN I remembered your stuff and instead of trying to ELIMINATE lines, I decided to accentuate them
Just beginning to look good at .3 spacing and Just about to go .5"BN.
THANKS (cut time down to 1:55 from 7-9minutes