ezurick wrote:Awesome design and project. First, keep in mind I am a newbie and I am limited to a Chinese 6040 machine. I really want to try this but I am a little confused on some parts and rather reluctant to think my wood is accurate in thickness, which would be extremely critical to the build. I see many folks here have access to all kinds of exotic accurate thickness wood. Besides super expensive online/shipping, all I have here in this desolate NC land is box stores. And my Lowes don't carry anything good besides their expensive red oak. Many of my simple projects are done with the cheap whiteboard/pine that Lowes sell. Since they are never accurate, I bought a nice 13" Wen planer. However, I still seem to get inaccurate thickness because the wood is purchased with different thickness on the same board. I am old and retired and can't afford expensive boards to play with. I can plane a .75 inch pine board down a few passes on each side and my result is as an example .69 inch on one side and .64 on the other side. It's because the original is already out of whack and I have no idea how to correct it.
Anyway, reading thru the whole thread I see no one talks about that back board and how they made it. Or perhaps I missed it somehow. I assume you use the top large drawer as the pattern for the hole in that back board. Next is the thickness or depth issue. In my case, since I have different thickness in my cheap wood; I would be better off cutting and completing the whole project before knowing how high the back board will be.
Remember, I am a newbie with everything, so don't bark too loud and hurt my feelings... lol. But it is an awesome project that I really like. Thanks.... ~ Ed
Users browsing this forum: No registered users and 8 guests