Needed a quick project

Post by **Aussie** » Fri Apr 17, 2020 3:09 am

Looking after my 6YO Grandson I needed a quick project to keep him amused, he got bored watching the cutting after a couple of minutes.
We spent the afternoon sanding and putting the parts together.
Thank you Makecnc.com for the template.

Post by **scotttarnor** » Fri Apr 17, 2020 4:18 am

That is pretty cool !

Post by **scottp55** » Fri Apr 17, 2020 9:46 am

Quick thinking to make a quick cutting project, Yet still a learning sharing experience Ron

Well done!
(he wasn't interest in multi hour 3D prep and cutting??

scott

Post by **Aussie** » Sat Apr 18, 2020 6:58 am

scottp55 wrote: ↑
Fri Apr 17, 2020 9:46 am
Quick thinking to make a quick cutting project, Yet still a learning sharing experience Ron
Well done!
(he wasn't interest in multi hour 3D prep and cutting??
scott

I am breaking him in gently..... this weekend we shall pull it apart and paint it.

Post by **scottp55** » Sat Apr 18, 2020 8:20 am

"...Slowly we go...Inch by inch...Step by step..."

He'll have some fond memories of you and your Shop if you keep that up Ron!
scott

Post by **Aussie** » Mon Apr 20, 2020 1:00 am

scottp55 wrote: ↑
Sat Apr 18, 2020 8:20 am

"...Slowly we go...Inch by inch...Step by step..."
He'll have some fond memories of you and your Shop if you keep that up Ron!
scott

Finished yesterday when my Grandson was visiting.

Post by **scottp55** » Mon Apr 20, 2020 1:13 am

Bet you both had fun....(except for cleaning up afterwards:)
Looks good for him to take home:)
scott

Vectric Customer

Needed a quick project

Needed a quick project

Re: Needed a quick project

Re: Needed a quick project

Re: Needed a quick project

Re: Needed a quick project

Re: Needed a quick project

Re: Needed a quick project