House Warming Cutting Board

An area to upload images of pieces cut using VCarve Pro
Post Reply
Ken Tipton
Vectric Apprentice
Posts: 70
Joined: Mon Feb 06, 2017 7:07 pm
Model of CNC Machine: Laguna IQ
Location: Ladera Ranch CA

House Warming Cutting Board

Post by Ken Tipton »

Here is a house warming present for the In-Laws. They are moving from Michigan to Nevada. I put rubber feet on the base so it won't slide around if they decide to use it. Since it is two sided I couldn't put feet on the actual cutting board so I built the base. The board sits about 1/2" into the base. I also added handles to it after these pictures were taken.
Attachments
Top.jpg
bottom.jpg

joeporter
Vectric Wizard
Posts: 519
Joined: Tue Jul 21, 2009 8:22 pm
Model of CNC Machine: ShopBot Buddy Standard
Location: Marietta, GA.

Re: House Warming Cutting Board

Post by joeporter »

Very nice, shows a lot of work and thought...joe

User avatar
mtylerfl
Vectric Archimage
Posts: 5865
Joined: Thu Jan 29, 2009 3:54 am
Model of CNC Machine: -CarveWright CNC -ShopBot Buddy PRSAlpha
Location: Brunswick, GA

Re: House Warming Cutting Board

Post by mtylerfl »

What a great idea, Ken! Wonderful gifts!
Michael Tyler

facebook.com/carvebuddy

-CarveWright CNC
-ShopBot Buddy PRSAlpha CNC

User avatar
scottp55
Vectric Wizard
Posts: 4713
Joined: Thu May 09, 2013 11:30 am
Model of CNC Machine: ShopbotDesktop 5.5"Z/spindle/VCP11.5
Location: Kennebunkport, Maine, US

Re: House Warming Cutting Board

Post by scottp55 »

VERY thoughtful and well executed Ken! :)
What were the woods used?
What flat depth did you decide on for the female pocket?
NICE present!!
scott
I've learned my lesson well. You can't please everyone,so you have to please yourself
R.N.

Ken Tipton
Vectric Apprentice
Posts: 70
Joined: Mon Feb 06, 2017 7:07 pm
Model of CNC Machine: Laguna IQ
Location: Ladera Ranch CA

Re: House Warming Cutting Board

Post by Ken Tipton »

The wood is Wenge and Mahogany. as for the female it was 1/2 90 degree v bit at .2 dept and the male at .1 and .1

User avatar
scottp55
Vectric Wizard
Posts: 4713
Joined: Thu May 09, 2013 11:30 am
Model of CNC Machine: ShopbotDesktop 5.5"Z/spindle/VCP11.5
Location: Kennebunkport, Maine, US

Re: House Warming Cutting Board

Post by scottp55 »

Thanks Ken!
Yeah, that depth combo works very well :)
I hope they treasure it.
scott
I've learned my lesson well. You can't please everyone,so you have to please yourself
R.N.

Post Reply