This section is for general discussion about Gadgets
I've used it on my ShopBot to cut paper and vinyl. I do not use the gadget. I create the vectors and use a standard profile toolpath "machine on vector". Just follow the instructions for setup that comes with the knife. A little experimentation with feed rate will be necessary.
I have found that the 45 degree blade works best for both paper and vinyl. I also use a vacuum hold down and have created some outstanding vinyl graphics for my Harley.
- Vectric Apprentice
- Posts: 65
- Joined: Tue Jan 24, 2006 11:57 am
- Location: Imperial, PA USA
Return to Gadgets - General
Who is online
Users browsing this forum: No registered users and 2 guests