I hope someone has a trick to gluing up the mother's keepsake box? I find I have to be an octopus in order to assemble the 4 sides and bottom, and then try to clamp them with out them moving and smearing glue all over the place. Do I have to make a holding jig? If so, does anyone have a plan for one?
Thanx in advance.
Mother's Keepsake Glue-up
- SteveNelson46
- Vectric Wizard
- Posts: 2304
- Joined: Wed Jan 04, 2012 2:43 pm
- Model of CNC Machine: Camaster Stinger 1
- Location: Tucson, Az.
Re: Mother's Keepsake Glue-up
Michael has assembly instructions in this thread.
http://forum.vectric.com/viewtopic.php?f=27&t=11147
http://forum.vectric.com/viewtopic.php?f=27&t=11147
Steve
- dwilli9013
- Vectric Wizard
- Posts: 1237
- Joined: Mon Sep 30, 2013 12:45 am
- Model of CNC Machine: 3 axis Self Designed Self Built
- Location: Machesney Park Illinois
Re: Mother's Keepsake Glue-up
Man you guys are quick. Actually a couple of pictures in the thread to aide in the glue up clamp scheme.SteveNelson46 wrote:Michael has assembly instructions in this thread.
http://forum.vectric.com/viewtopic.php?f=27&t=11147
http://forum.vectric.com/viewtopic.php?f=41&t=11147
D-Dub
Dwayne
Dwilli
Dwayne
Dwilli
- mtylerfl
- Vectric Archimage
- Posts: 5892
- Joined: Thu Jan 29, 2009 3:54 am
- Model of CNC Machine: -CarveWright CNC -ShopBot Buddy PRSAlpha
- Location: Brunswick, GA
Re: Mother's Keepsake Glue-up
Set the base onto scraps leftover from your cut parts. this serves as a platform to raise the base off the table surface.async4 wrote:I hope someone has a trick to gluing up the mother's keepsake box? I find I have to be an octopus in order to assemble the 4 sides and bottom, and then try to clamp them with out them moving and smearing glue all over the place. Do I have to make a holding jig? If so, does anyone have a plan for one?
Thanx in advance.
Glue the back panel and two sides to the elevated base. Use masking tape to hold the parts if you wish, then glue on the front panel.
Check for square and clamp until dry.
Here's a couple photos for you...
EDIT: Thank you guys for adding that link. I forgot all about that! (my post is redundant - took over 45 minutes to upload due to icky internet here at the hotel I'm at in Ohio)
Michael Tyler
facebook.com/carvebuddy
-CarveWright CNC
-ShopBot Buddy PRSAlpha CNC
facebook.com/carvebuddy
-CarveWright CNC
-ShopBot Buddy PRSAlpha CNC
Re: Mother's Keepsake Glue-up
Ya know what goes first with age? Memory! I am so thankful for you guys. I was trying to glue all 5 pieces at one time!
talk about a brain fart!
Thank you all so much!
talk about a brain fart!
Thank you all so much!