Free Project - The "Pierced Tin" Tea Chest

Free Project - The "Pierced Tin" Tea Chest

Postby AmritpalP » Tue Jun 02, 2015 11:05 am

Michael Tyler brings you yet another great project for all you hot beverage drinkers. This unique Tea Chest has three interior compartments to attractively stow 45+ tea bags near your beverage area in your kitchen or dining room. The lid design features a faux "pierced tin" effect which is accentuated by dabbing silver paint on the pierced area panel.

This project is available to Aspire 8.0 users or higher.

Image

The finished dimensions of this project are approximately 12.5 " W x 6.75 " D x 4.375 " T.

Click the link to download the project pack: http://www.vectric.com/cool-stuff/projects/2015/TeaChest.html

If you go ahead and create this project, then it would be great to see a photo of your finished piece over on the Vectric Forum. Alternatively feel free to email us a picture of your finished piece at online@vectric.com.
Graphic & Web Designer

www.vectric.com
AmritpalP
Vectric Staff
 
Posts: 67
Joined: Tue Jun 10, 2014 10:42 am
Model of CNC Machine: ShopBot

Re: Free Project - The "Pierced Tin" Tea Chest

Postby bill565 » Wed Jun 03, 2015 1:16 pm

Good morning.

Just a quick clarification please.

On the project page under the not is a reference that this project is for both Aspire and scarves, however all other references are Aspire.

Is the project compatible with vacarve? I like the look and the PDF looks straight forward.

Here is the snip from the project page that I refer too.

Download project filesDownload project pdf

Note:
This free Vectric project requires Aspire 8.0/ VCarve 8.0 or higher.


Thanks bill
Save the Whales, Collect the Whole Set
http://www.bcnc-fab.com
User avatar
bill565
Vectric Craftsman
 
Posts: 114
Joined: Sat May 10, 2008 4:58 pm
Location: Jafrey New Hampshire
Model of CNC Machine: One of those "Practical"4x4s

Re: Free Project - The "Pierced Tin" Tea Chest

Postby JamesB » Wed Jun 03, 2015 4:53 pm

Apologies for the confusion, this project does require Aspire 8 as indicated at the top of the page. We'll correct the typo at the bottom.
Thanks,
James
User avatar
JamesB
Vectric Alumni
 
Posts: 1248
Joined: Tue May 30, 2006 1:24 pm
Location: Warwickshire, UK
Model of CNC Machine: None


Return to Projects of the Month

Who is online

Users browsing this forum: No registered users and 1 guest