Precix Metric Post

Post by **Rarebyte** » Sat Dec 23, 2006 1:19 am

Hello
I have a metric file to cut on my Precix router. Can I use the Precix Post Processor (inch) (*. GC) if I change the G70 command to G71 in the header of the code.

Example:
Precix Inch

%
G90 G70 G17 G40
M10

Can I change to

%
G90 G71 G17 G40
M10

Is this all I need to do to cut a metric V-Carve code or is there more to change internally. The V-Carve code was made from a metric dxf and all the tooling and material set ups were done in Metric. There just is no Precix metric post processor in the list when I output the files.

Thank you

Post by **Tony Mac** » Sat Dec 23, 2006 12:14 pm

Hello Rarebyte,

I have e-mailed you a metric version of the postp + notes on how to add this to your install.

Tony

Post by **Tony Mac** » Sat Dec 23, 2006 2:11 pm

Rarebyte,

Messages to your registered e-mail address are being bounced back?

Please e-mail - support@vectric.com - and we will reply with the information.

Tony