Hey I have had this little quirk since I first installed my router when I use vcarve. It seems that vcarves output does not instruct my router to turn on after starting. the file is loaded correctly, then when I hit start technos controler software askes for a tool to be loaded. Once I load the tool and hit start the x,y,and z all begin moving but I have to pause and restart for the router to start up. At the end of the file the router returns to where it should but does not turn off.
Everything else works great but this is a little inconvienent.
Techo post or Techno problem
Techo post or Techno problem
Last edited by Kimon on Fri Nov 03, 2006 7:36 pm, edited 1 time in total.
Hi Kimon,
Has this been sorted out by James?
If anyone else has a Techno and is experiencing the same problem please
e-mail support@vectric.com and we will send you the updated postp.
Tony
Has this been sorted out by James?
If anyone else has a Techno and is experiencing the same problem please
e-mail support@vectric.com and we will send you the updated postp.
Tony