We have created an area on the web site for downloading new postp's when they become available.
These postp's can be used with both the Full and Trial versions of VCW and are very simple to install.
The new Mach2/3 and TurboCNC (Inch & Metric) postprocessors are available from the link below,
http://www.vectric.com/vectric/images/t ... /index.htm
Installation notes are also available from the page.
If you have any problems installing the postps or need our assistance please e-mail - support@vectric.com
Regards,
Tony Mac
New Postprocessors for Mach2/3 and TurboCNC
New Postprocessors for Mach2/3 and TurboCNC
Last edited by Tony Mac on Mon Nov 28, 2005 11:39 am, edited 1 time in total.
Hello Tony,
I recently purchased VCarve and am having fun - just waiting for one of my routers to free up to make some samples.
In regards to your Mach2/3 post processor - I found an error in it. Near the end of it, there is a G00 command that mistakenly reads Go0 (G, followed by the LETTER o, then the number 0). Of course, it should be G00 (no letter o).
Thought I would pass this along to you and those using the Mach2/3 pp.
Love your product!
Mark
I recently purchased VCarve and am having fun - just waiting for one of my routers to free up to make some samples.
In regards to your Mach2/3 post processor - I found an error in it. Near the end of it, there is a G00 command that mistakenly reads Go0 (G, followed by the LETTER o, then the number 0). Of course, it should be G00 (no letter o).
Thought I would pass this along to you and those using the Mach2/3 pp.
Love your product!
Mark