Processor for Mach 3 Mill

Post by **Rik** » Tue Nov 22, 2005 11:44 pm

I am about to set up my machine using Mach 3 Mill by Artsoft per chance do you have a post for this?

Post by **Tony Mac** » Wed Nov 23, 2005 12:10 am

Hi Rik,

Yes, the attached zip file contains both the Inch and Metric postprocessors for Mach2/3.

Copy the files into the folder,

C:\Program Files\VCarve Wizard 2.0\PostP

Restart the software and the new postps will be available in the pull-down list on the Save Toolpath form.

Mach2/3 (inch) (*.txt)
Mach2/3 (mm) (*.txt)

If you have any problems installing the postps or need our assistance please e-mail - support@vectric.com

Regards,

Tony Mac