vectric to mach2 problems

Post by **coop** » Tue Sep 19, 2006 9:28 pm

my first post
have new 3925 k2cnc machine
all upgrades
vcarvepro trial
mach2
problems
all g code loads come out partial
or diff sizes
tried k2 post processor
tried mach2/3 post
i did manage to get one evaluation file to load correctly
and do an "air" cut.. it was the outline vector in the engrave sample file
but the fonts in the same file come out partial ???
help, please

Post by **CRFultz** » Wed Sep 20, 2006 1:32 am

Hi Coop,
Welcome to the Vectric forum....
If you will post your g code output here on the forum, i will take a look at it and see
if the problem is in the code or in the mach settings....I use Mach 3 but it should give us a ideal where the problem is coming from.

Chuck

Post by **coop** » Wed Sep 20, 2006 2:47 am

thanks Chuck,
i will attach the g code file
asap in the AM
I anticipated these problems but new I could fing help to resolve them !
thanks again
coop[/b]

Post by **coop** » Wed Sep 20, 2006 6:09 pm

hey chuck, how are you ?
here is the g code
this is just one that did not come through okay[/b]
the second (test7) file came out okay...they were from the same sample file.

Post by **CRFultz** » Wed Sep 20, 2006 8:06 pm

Coop,
the first txt file is over 380k long.....do you have a registered version of Mach 2?
The eval version is limited on how many lines you can run.
other then that it appears ok.

Chuck

Post by **coop** » Thu Sep 21, 2006 2:08 am

thanks for looking at the code
I was using the trial versions of both programs.
I will purchase both and see how that works !
I'll keep you posted.
thanks again
bo