I am having problems trying to post a cut file. When I select Mach2/3 (inch) txt the code puts a G21 into the header of the code which turns on metric(it should be G20.) I have tried using the metric one to see if it cuts inch, but does not.
Is there a way to fix this?
Rich
Mach 2/3 post problems
Hello Rich,
The Mach2/3 Inch postp in VCPro 3.0 is broken and will be fixed in the next release.
In the mean time you can either,
Use the Mach2/3 ATC (inch) (*.txt) postp available from the
pull-down list on the Save Toolpath form.
Or,
Download the attached postp file and copy this into the folder,
C:\Program Files\VCarve Pro 3.0\PostP
Replacing the original
Sorry for any inconvenience caused by this and let us know if you need further assistance.
Tony
The Mach2/3 Inch postp in VCPro 3.0 is broken and will be fixed in the next release.
In the mean time you can either,
Use the Mach2/3 ATC (inch) (*.txt) postp available from the
pull-down list on the Save Toolpath form.
Or,
Download the attached postp file and copy this into the folder,
C:\Program Files\VCarve Pro 3.0\PostP
Replacing the original
Sorry for any inconvenience caused by this and let us know if you need further assistance.
Tony
- Attachments
-
- Mach2_3_inch.zip
- Mach2/3 postp with fixed units - G20
- (881 Bytes) Downloaded 324 times