Some of you on this board have really tried to help me get going on my machine and I appreciate it. I did what was recommended next
which was to email support but nobody has responded?
Adrian wrote:Going by the many previous posts on the forum about Biesse machines the issue isn't really the Post Processor. It's the control software that the Biesse uses and the way that works with 3rd party files. I would contact the supplier of the machine and get the exact process from them.
When you email support are you using the email address that you registered/purchased the Vectric software under? Not sure if they check support queries at that level but given there are illegal copies of the software around I wouldn't be surprised.
Users browsing this forum: No registered users and 3 guests