Hey IslaWW... So i ran the file today and it did the same thing as mine... Showed up in Biessworks with only the geometry showing no sign of any tooling. Im attatching a screenshot from my machine today when trying to run your file.IslaWW wrote:CRV opened fine. Using your toolpaths, I posted this with the Biesse Skill G FT (ISO*) postP included with VCarve Pro. I didn't audit line by line, but for the most part the header reads the same as your posted ISO file.
I am attaching the file for you to look over, or load into the machine for an air cut to see if it returns any errors. I added the TXT extension to allow posting on the forum. Remove the ".TXT" before attempting to load.
1.) You will see that on the far left towards the top is the geometry from the part, normally the milling or drilling are below the geometries but there are none.
2.) On the right top of the image you can see the sheet with the part not even on the sheet, but thats irrelevant. The geometries are normally highlighted in blue if they are created correctly. They are not due to no tooling.
3.) On the bottom you will see the code... As you can see it doesnt look like gcode obviously but thats the biesse code.
And there are no tools/drills associated with anything there.
Any ideas?