ATC Spindle - anybody using this one?

This forum is for requests and queries about machine tool support for Vectric Products

ATC Spindle - anybody using this one?

Postby dbrook » Tue Aug 09, 2016 2:34 am

I am interested replacing my Hitachi router with a spindle and would love to have a tool change spindle. Before I seriously consider dropping that much cash I wanted to check to see if anybody on the forum has had any experience with this ATC spindle. It can be found on the Automationtechnologies.com spindle page. http://www.automationtechnologiesinc.co ... kl-2200atc

Any input on the spindle and the company would be most appreciated.

See attached picture.

Dan
Attachments
Spindle-2.PNG
dbrook
 
Posts: 41
Joined: Wed Jul 27, 2011 3:36 am
Location: Starkville, MS
Model of CNC Machine: 4x4 DIY Router

Re: ATC Spindle - anybody using this one?

Postby ger21 » Wed Aug 10, 2016 1:53 am

Automation Technologies is a reputable company. However, all they really do is import chinese goods and resell them. If you need support for anything you buy from them, don't expect a lot.

I've only seen one or two people using chinese ATC spindles, and I doubt that they were that exact model. There are a lot of different manufacturers of those spindles.
Gerry
ger21
Vectric Wizard
 
Posts: 854
Joined: Sun Sep 16, 2007 2:59 pm
Location: Shelby Township, MI, USA


Return to Post Processors

Who is online

Users browsing this forum: No registered users and 3 guests