I have been using tape split function through v-carve pro 8.0..However with the recent update, I haven't been able to use this function. When I try to save the tool path I get a writing error..Anyone know why or what I need to do to fix this. If I open 8.0 or lower it works fine.
Thanks in advance
Tape split doesn't work
- Adrian
- Vectric Archimage
- Posts: 14683
- Joined: Thu Nov 23, 2006 2:19 pm
- Model of CNC Machine: ShopBot PRS Alpha 96x48
- Location: Surrey, UK
Re: Tape split doesn't work
What does the error say exactly?
Re: Tape split doesn't work
Sorry for the dealy- Work schedule..here is the message..Appreciate the help.
- Adrian
- Vectric Archimage
- Posts: 14683
- Joined: Thu Nov 23, 2006 2:19 pm
- Model of CNC Machine: ShopBot PRS Alpha 96x48
- Location: Surrey, UK
Re: Tape split doesn't work
Is that the correct path? Seems a strange place to be saving toolpaths. Is that path the same in V8?
Re: Tape split doesn't work
It doesn't matter where I try to save it too, that the message I get. albeit the location will change to where I try to save it too..Whether I try to a hard disk, flash drive etc. Like I say, worked fine up to version 8.5
- IslaWW
- Vectric Wizard
- Posts: 1403
- Joined: Wed Nov 21, 2007 11:42 pm
- Model of CNC Machine: CNC Controller Upgrades
- Location: Bergland, MI, USA
Re: Tape split doesn't work
In the off chance that that file is read only, have you tried saving under a different name?
Gary Campbell
GCnC Control
ATC & Servo Controller Controller Upgrades
GCnC411 (at) gmail.com
GCnC Control
ATC & Servo Controller Controller Upgrades
GCnC411 (at) gmail.com
Re: Tape split doesn't work
Yes sir..I've tried saving under different names, locations even went into the folder and made sure it had read and write settings in the properties...I just don't know why it works fine up until the upgrade. I'm at a loss
- mtylerfl
- Vectric Archimage
- Posts: 5896
- Joined: Thu Jan 29, 2009 3:54 am
- Model of CNC Machine: -CarveWright CNC -ShopBot Buddy PRSAlpha
- Location: Brunswick, GA
Re: Tape split doesn't work
Have you contacted Vectric Support and sent them the file? They will be able to tell you what's up.jpatton wrote:I have been using tape split function through v-carve pro 8.0..However with the recent update, I haven't been able to use this function. When I try to save the tool path I get a writing error..Anyone know why or what I need to do to fix this. If I open 8.0 or lower it works fine.
Thanks in advance
Michael Tyler
facebook.com/carvebuddy
-CarveWright CNC
-ShopBot Buddy PRSAlpha CNC
facebook.com/carvebuddy
-CarveWright CNC
-ShopBot Buddy PRSAlpha CNC