which post to use?

This forum is for requests and queries about machine tool support for Vectric Products

which post to use?

Postby bruce larson » Wed May 18, 2016 10:11 pm

I have a Multicam machine with the newest job server software installed in the last 2 weeks. The files I have tried to run, the post does not show the tool on my control pendant like the old Enroute Pro 3D post did. Also when I tried to do a roughing and finish pass, it does not call out the change or new tool name.
I assume I should be using a different post, but I don't know which ones to try.
bruce larson
Posts: 1
Joined: Fri May 13, 2016 8:44 pm
Model of CNC Machine: Multicam 22 plus

Return to Post Processors

Who is online

Users browsing this forum: No registered users and 5 guests