need help with C1090 C series controller

This forum is for requests and queries about machine tool support for Vectric Products
Post Reply
jamore
Vectric Apprentice
Posts: 50
Joined: Wed Jun 22, 2011 11:06 pm
Model of CNC Machine: techno

need help with C1090 C series controller

Post by jamore »

Hi.. to all you clever cnc fundies,

Is there still some one somewhere in the world who use's the above mentioned Controller. i realize that it is a very old controller and hope that some one will be able to help me fixing mine.

i used mine for quite a number of years, but all of a sudden it just gave me a ERROR code @#1 when i try to cut a file.

When i switch the controller on the X & Y stepper motors "Home" but nothing happen with the Z Stepper motor.
I switched around the amplifiers and cables, but cant get the Z axis to move. i took it to an electronic place who works on controllers and working through one of techno people we still cannot get the Z stepper motor to move when switching on the controller.

i attached the controller booklet below to show what the controller look like. See page 10

i will thank you

jamore :?
Attachments
0043_C-Series Wiring Setup and ASCII Programming Manual.pdf
(1.25 MiB) Downloaded 227 times

Post Reply