Vectric Fanuc PP will not run

[darrylh]

Fanuc mm tap PP will not run on Fanuc OM Mill. Any suggestions for one that will work???? (though this PP seems the most appropriate in the list)

[Mark]

Hello darrylh,

You have not mentioned which product you wish to use with the machine, VCarve Pro and Aspire ship
with Fanuc 0i and Fanuc 16 post processors that might work for you.

I hope that this helps.

Cheers,

Mark.

[darrylh]

using Aspire. In terms of the post descriptions the 0i (ATC) did not seem right, so I chose the fanuc mm tap. The latter seems to omit all the G01 and G02 commands that I would normally expect to see in my program lines. In other words, all the post did was to compile the X, Y and Z co-ords....and nothing else. I will try the 0i PP and see what happens.

[darrylh]

The Oi PP is inch, so no good to me. The 16 PP drags in I and J Gcode, which I have never seen before in any of my Fanuc progs, so unsure what would happen if run on the CNC. Any Fanuc users out there to advise which post?? Or does support have the right Fanuc post for millimetres?