WinPC-NC USB

[daibeer]

Hi all,
Sorry for a newbie question so here it is.
I have Cut2D and WinPC-NC USB, and am used to working in inches. I am a complete newcomer to the CNC world. When I go to save my toolpath, the only WinPC post processor is WinPC-NC Arcs mm (*.nc) which I presumed was in metric. Can anyone advise me which Post Processor to choose. Thank you very much for your help.
regards
Dave

[Sara M]

Hello Daibeer,

Please send us an email to - support@vectric.com from the email address that you used to buy/register your
copy of Cut 2D and request the post processor for WinPC-NC Arcs in inches. We will email you a copy
of the requested post processor.

I hope that this helps.

Kind regards,

Sara

[daibeer]

Hi Sara
Hopefully my registration is going through as we speak. I bought the machine along with the software two weeks ago from a person in Yorkshire so the appropriate people on your end are verifying the sale with the last owner. I will wait until I get registered and post again. Thanks your help
Dave

[daibeer]

Hi Sara
Sorry for long delay but I havnt heard anything about my registration. Plus Ive lost the ser no etc when my PC crashed. Whats the best to do now?
regards
Dave

[Mark]

Hello daibeer,

If you could drop us an email to support, we will try to get you going.

I Hope that this helps,

Cheers,

Mark.

[daibeer]

Hi Mark,
will do, thanks
Dave