Hi all,
Sorry for a newbie question so here it is.
I have Cut2D and WinPC-NC USB, and am used to working in inches. I am a complete newcomer to the CNC world. When I go to save my toolpath, the only WinPC post processor is WinPC-NC Arcs mm (*.nc) which I presumed was in metric. Can anyone advise me which Post Processor to choose. Thank you very much for your help.
regards
Dave
WinPC-NC USB
Re: WinPC-NC USB
Hello Daibeer,
Please send us an email to - support@vectric.com from the email address that you used to buy/register your
copy of Cut 2D and request the post processor for WinPC-NC Arcs in inches. We will email you a copy
of the requested post processor.
I hope that this helps.
Kind regards,
Sara
Please send us an email to - support@vectric.com from the email address that you used to buy/register your
copy of Cut 2D and request the post processor for WinPC-NC Arcs in inches. We will email you a copy
of the requested post processor.
I hope that this helps.
Kind regards,
Sara
-
- Vectric Craftsman
- Posts: 107
- Joined: Fri Mar 15, 2013 9:15 pm
- Model of CNC Machine: Heiz S-1000
Re: WinPC-NC USB
Hi Sara
Hopefully my registration is going through as we speak. I bought the machine along with the software two weeks ago from a person in Yorkshire so the appropriate people on your end are verifying the sale with the last owner. I will wait until I get registered and post again. Thanks your help
Dave
Hopefully my registration is going through as we speak. I bought the machine along with the software two weeks ago from a person in Yorkshire so the appropriate people on your end are verifying the sale with the last owner. I will wait until I get registered and post again. Thanks your help
Dave
-
- Vectric Craftsman
- Posts: 107
- Joined: Fri Mar 15, 2013 9:15 pm
- Model of CNC Machine: Heiz S-1000
Re: WinPC-NC USB
Hi Sara
Sorry for long delay but I havnt heard anything about my registration. Plus Ive lost the ser no etc when my PC crashed. Whats the best to do now?
regards
Dave
Sorry for long delay but I havnt heard anything about my registration. Plus Ive lost the ser no etc when my PC crashed. Whats the best to do now?
regards
Dave
- Mark
- Vectric Staff
- Posts: 1058
- Joined: Sat Aug 18, 2007 2:55 pm
- Model of CNC Machine: CNC Shark, ShopBot, Roland PNC3000
- Location: Alcester U.K.
- Contact:
Re: WinPC-NC USB
Hello daibeer,
If you could drop us an email to support, we will try to get you going.
I Hope that this helps,
Cheers,
Mark.
If you could drop us an email to support, we will try to get you going.
I Hope that this helps,
Cheers,
Mark.
-
- Vectric Craftsman
- Posts: 107
- Joined: Fri Mar 15, 2013 9:15 pm
- Model of CNC Machine: Heiz S-1000
Re: WinPC-NC USB
Hi Mark,
will do, thanks
Dave
will do, thanks
Dave