I have a intellicarve 1013 with i-picture. I downloaded photo v carve trial version. My post processor is not in it,so i called and got a post processor by email.I put the file in the post processor file forphoto trial,but it will not show up in the trial version when i try to make a sample.icarver post prosessor is mine.
Any suggestions will be appreciated.
post processor
- Mark
- Vectric Staff
- Posts: 1058
- Joined: Sat Aug 18, 2007 2:55 pm
- Model of CNC Machine: CNC Shark, ShopBot, Roland PNC3000
- Location: Alcester U.K.
- Contact:
Re: post processor
Hello,
The post processors that I sent to you were suitable for VCarve Pro, I am afraid that
they are not suitable for PhotoVCarve. In your email you mention VCarve Pro.
I will send you a version suitable for PhotoVCarve.
I hope that this helps.
Cheers,
Mark.
The post processors that I sent to you were suitable for VCarve Pro, I am afraid that
they are not suitable for PhotoVCarve. In your email you mention VCarve Pro.
I will send you a version suitable for PhotoVCarve.
I hope that this helps.
Cheers,
Mark.