Hello,Im new here!!
I have downloaded the Aspire Trial version.My machine is Artis X Hamuel Reichenbacher (5 Axis).
Do i have to install any program to the machine in order to load the file i have exported from the PC?
Thank you!
Loading to machine
- Adrian
- Vectric Archimage
- Posts: 14660
- Joined: Thu Nov 23, 2006 2:19 pm
- Model of CNC Machine: ShopBot PRS Alpha 96x48
- Location: Surrey, UK
Re: Loading to machine
How do you normally run files on the machine?
If it's controlled by a PC then you need to load the Aspire produced toolpath file into the control software that you run on that PC.
If it's a built-in controller then you need to transfer the file into that via USB or floppy disk.
If it's controlled by a PC then you need to load the Aspire produced toolpath file into the control software that you run on that PC.
If it's a built-in controller then you need to transfer the file into that via USB or floppy disk.