Good Afternoon,
I have an old Roland CAMM2 PNC 2200A which I can engrave 2d quite easily. Can anybody tell me if Vectric software will run this old machine and how to set up a post processor to run it. I have downloaded trial software, and loaded a 2.5 d driver for the roland, but as yet been unable to send data the machine controller with any success.
Thanks to anyone in anticipation for an answer.
Steve
Making Vectric software power a Roland CAMM2 PNC 2200A
-
- Posts: 2
- Joined: Wed May 02, 2012 10:27 pm
- Model of CNC Machine: Roland CAMM-2 PNC2100-A