Can some one tell me how to imprt the toolpath from photoV carve to V carve.
Thanks
prempadma
imprting tool path from PhotoV carve to V carve
-
- Vectric Wizard
- Posts: 4797
- Joined: Thu May 18, 2006 3:24 pm
- Model of CNC Machine: ShopBot
- Location: North Carolina
Re: imprting tool path from PhotoV carve to V carve
Look at the bottom tutorial, #9, on this page:
http://www.vectric.com/WebSite/Vectric/ ... esign.html
There is both a video and written document and these should get you going in the right direction.
Tim
http://www.vectric.com/WebSite/Vectric/ ... esign.html
There is both a video and written document and these should get you going in the right direction.
Tim
Re: imprting tool path from PhotoV carve to V carve
I've encountered the same problem. The solution offered in the tutorial video doesn't work, the "save as" function is grayed out.
- Adrian
- Vectric Archimage
- Posts: 14650
- Joined: Thu Nov 23, 2006 2:19 pm
- Model of CNC Machine: ShopBot PRS Alpha 96x48
- Location: Surrey, UK
Re: imprting tool path from PhotoV carve to V carve
Are you using the trial version? I think the Save As only works in the full version.