Hi,
I wonder, how I can change my Cut2D prostprozessor for the following feature:
- after going to /0 I would like to have a pause of around 200ms before I start the actual cut.
- the reason for that is, that I broke a lot of tiny engraver when I cut 3mm CFK plates.
Any suggestions, how I can do this?
Jens
Pause auf Z0
Re: Pause auf Z0
hi jens
greeting on the forum
you can edit postprocessor and it will place delay in gcode... but in your case more helpful to keep the z speed slow so your bit will get the force gradually...
in cut2d your option is slow down the z movement... in toolsettings you need to set the z speed, (plunge) down as low as your bit can take the stress.. (example a 30-100 mm/min might works)
in vcarve you can set ramping what makes you keeping z plunge on high speed...
for final solution you can set ramp in gode...
viktor
greeting on the forum
you can edit postprocessor and it will place delay in gcode... but in your case more helpful to keep the z speed slow so your bit will get the force gradually...
in cut2d your option is slow down the z movement... in toolsettings you need to set the z speed, (plunge) down as low as your bit can take the stress.. (example a 30-100 mm/min might works)
in vcarve you can set ramping what makes you keeping z plunge on high speed...
for final solution you can set ramp in gode...
viktor