Feed rate in IPM

This forum is for requests and queries about machine tool support for Vectric Products

Feed rate in IPM

Postby cbr_speedster » Wed Apr 11, 2018 2:35 am

I'm using the Laguna IQ Metric post and it works fine but would like to get the inch post to work but the feed rate doesn't work. It cuts very slow like it's maintaining the metric setting so at 70 IPM it's like .007 IPM. I tried IPM, IPS, FPM and all are way too slow. In a mill program the G94/G95 switches from IPM/IPR but no luck with that. Added a G20/G70 in the beginning with no help. There's got to be something missing to get the feed rate to work in the inch post. Any ideas would be greatly appreciated.
Jeff

Sample of output
N1 (Filename: Junk1)
N2 (Machine: Laguna IQ)
N3 ( Material Size)
N4 ( X= 10.000, Y= 3.125, Z= 0.750)
N5 G90
N6 G20
N7 M03 S12000
N8 G00 X3.652 Y1.194 Z0.200
N9 G01 Z-0.046 F30.0
N10 G01 X3.650 Y1.205 Z-0.043 F70.0
cbr_speedster
Vectric Apprentice
 
Posts: 9
Joined: Fri Mar 23, 2018 12:08 pm
Model of CNC Machine: Laguna IQ

Re: Feed rate in IPM

Postby IslaWW » Wed Apr 11, 2018 2:51 am

Does the IQ use the Richauto A11 controller? IF so, it will only accept metric units. You are most likely running at 30 and 70 mm/min. 70mm/m = 2.75"/min or .045" per second.

You may design in inches, set feedrates in inches and the post will convert into the format proper for the machine. That's what the post does.
Gary Campbell
CNC Technology & Training
Control & ATC Retrofits
GCnC411 (at) gmail.com
User avatar
IslaWW
Vectric Wizard
 
Posts: 974
Joined: Wed Nov 21, 2007 11:42 pm
Location: Marquette, MI, USA
Model of CNC Machine: SideWinder ATC & CNC Mill on WinCNC

Re: Feed rate in IPM

Postby cbr_speedster » Wed Apr 11, 2018 2:21 pm

Thanks Gary
cbr_speedster
Vectric Apprentice
 
Posts: 9
Joined: Fri Mar 23, 2018 12:08 pm
Model of CNC Machine: Laguna IQ


Return to Post Processors

Who is online

Users browsing this forum: No registered users and 3 guests