I have a 4 axis controller, I have a total of 4 stepper motors, can I wire the 2 "Y" motors to one and buy an indexer? In Mach3 the "Y" is set up with a slave, would the power to the motors change? Or can you tell me where to go to find this out?
Thanks
Gary
Indexer Question
Re: Indexer Question
I'm going to jump in here before you go and try it out, I know that with my hobby cnc board, it didn't like 2 motors on one axis It let the smoke out.
I have a 4 axis gecko drive now, and the directions say that you shouldn't hook up 2 motors to one drive either.
This may not be the case for all controllers, I expect someone more knowledgeable on the topic will come along soon.
I have a 4 axis gecko drive now, and the directions say that you shouldn't hook up 2 motors to one drive either.
This may not be the case for all controllers, I expect someone more knowledgeable on the topic will come along soon.