New rotary indexer problem

Topics related to wrapped rotary machining in Aspire or VCarve Pro
Post Reply
User avatar
Phil
Vectric Wizard
Posts: 3026
Joined: Thu Nov 17, 2005 10:56 pm
Location: Pittsfield, MA

New rotary indexer problem

Post by Phil »

Yesterday I turned a 1.375" dia x 9" long piece of softwood to 1.25" dia. I had trimed the corners to an octagon shape so the cut was very light. The cut went as expected. Next I used Aspire to create a spiral cut along the same piece. The tool ran as expected.
Today I set up to turn a 2.375" dia x 14" long piece of softwood to a 2.35" dia. I had trimed
the corners to an octagon shape so the cut was very light.
The cut started out fine but after a few passes along the X axis the rotary tool reversed rotation. After that it reversed again and again. I had to stop.
I shut everyting down, rebooted my laptop and tried again. Same results.
Is the problem with the indexer? What else could it be?

Phil

Post Reply