Is there an option to put an automatic center line thru the slanted boundaries of the spiral layout ?
Michael
center line
-
mezalick
- Vectric Wizard
- Posts: 2980
- Joined: Mon Nov 03, 2008 9:07 am
- Model of CNC Machine: Camaster Cobra
- Location: Philadelphia, PA USA
- Contact:
center line
Michael Mezalick
https://www.youtube.com/user/mezalick
mm@mezalick.com
https://www.youtube.com/user/mezalick
mm@mezalick.com
-
BrianM
- Vectric Staff
- Posts: 1964
- Joined: Mon May 16, 2005 10:15 am
- Model of CNC Machine: A few ...
- Location: Alcester U.K
- Contact:
Re: center line
Hi Michael,mezalick wrote:Is there an option to put an automatic center line thru the slanted boundaries of the spiral layout ?
Michael
Not automatic, but it only takes a few seconds to add one with the polyline tool as it will snap to the centre of the top and bottom spans which defiine the spiral area.
Brian
-
mezalick
- Vectric Wizard
- Posts: 2980
- Joined: Mon Nov 03, 2008 9:07 am
- Model of CNC Machine: Camaster Cobra
- Location: Philadelphia, PA USA
- Contact:
Re: center line
That'll work,
Thanks Again Brian
Thanks Again Brian
Michael Mezalick
https://www.youtube.com/user/mezalick
mm@mezalick.com
https://www.youtube.com/user/mezalick
mm@mezalick.com