The finished look in V-Carve does not look like what I get as a final result.
4DThinker wrote:You should check the Clearance (Z1) value on the Material SETup page of the toolpath menu. You can set it to a higher value to be sure the bit lifts higher up between paths/passes to clear parts it might rotate into. Yes, this is a slight "bug" in how rotary toolpaths are calculated. What would be easily cleared when the material is uwrapped flat can often end up in the way once the toolpaths are bent around the actual cylindrical model.
Hivoltage wrote:I forgot to add that I am using Mach3 and a gecko 540 controller for XYZ and the A is controlled by a TB6600
My issue could be how Mach3 is interpreting the code. Maybe there is some setting that can be changed to fix this. I do not know.
Users browsing this forum: No registered users and 4 guests