I have a round blank that is not completely round. It's largest diameter is 5 inches and the smallest is 4.75. I would like the round blank final diameter to be 4.75. What numbers do I put in
the rounding gadget to tell the machine what to do? When I enter 5 inch for the largest diameter and any other number less than 5 for the next
box for the amount of material to leave on the cylinder it gives me the error of : the diameter of the round blank (5) must be equal to or grater than the cylinder diameter + allowance. What does this mean?
Do I need to put the 4.75 value in diameter of the the round blank?
I have watched the video's over and over again. and it skips over what to enter for the allowance and instructions on rounding an already round blank.