Necesito AYUDA POR FAVOR
-
- Posts: 19
- Joined: Sat Feb 02, 2019 5:04 pm
- Model of CNC Machine: Auto construita, 4 ejes 1200mm, mach3
- Location: Milano Italia
Necesito AYUDA POR FAVOR
Yo estoy tratando de hacer este modelo con el postprocesor Mach2/3WrapX2A ATC (mm) y cuando voy a salvarlo me sale esta informacion en grados, quisiera saber si esos grados me sirven para el motor runing y que tipo de formula ho operazione debo hacer para cambiar los valores del enrollado en el motor running, osea no se que quiere decir esta informacion , para cargarlo en el mache3. Gracias.
- Leo
- Vectric Wizard
- Posts: 4091
- Joined: Sat Jul 14, 2007 3:02 am
- Model of CNC Machine: 1300 x 1300 x 254 Chinese Made
- Location: East Freetown, Ma.
- Contact:
Re: Necesito AYUDA POR FAVOR
Translated:
I am trying to make this model with the PostProcessor Mach2/3WrapX2A ATC (mm) and when I am going to save it I get this information in degrees, I would like to know if those degrees serve me for the running engine and what kind of formula ho operazione I must do to change the values of the roll in the running engine, I mean I don't know what this information means, to load it in the mache3. Thank.
I am trying to make this model with the PostProcessor Mach2/3WrapX2A ATC (mm) and when I am going to save it I get this information in degrees, I would like to know if those degrees serve me for the running engine and what kind of formula ho operazione I must do to change the values of the roll in the running engine, I mean I don't know what this information means, to load it in the mache3. Thank.
Imagine the Possibilities of a Creative mind, combined with the functionality of CNC
- Rcnewcomb
- Vectric Archimage
- Posts: 5920
- Joined: Fri Nov 04, 2005 5:54 am
- Model of CNC Machine: 24x36 GCnC/WinCNC with ATC
- Location: San Jose, California, USA
- Contact:
Re: Necesito AYUDA POR FAVOR
No, eso no es correcto. Parece que el trabajo se configuró para A paralelo al eje X, pero ahora está intentando dar salida para A paralelo al eje Y.
Además, siempre debes poner tu Z en el centro del cilindro.
No, that is not correct. It looks like the job was set up for A parallel to the X axis, but now you are trying to output for A parallel to the Y axis.
Also, you should always set your Z to the center of the cylinder
Además, siempre debes poner tu Z en el centro del cilindro.
No, that is not correct. It looks like the job was set up for A parallel to the X axis, but now you are trying to output for A parallel to the Y axis.
Also, you should always set your Z to the center of the cylinder
- Randall Newcomb
10 fingers in, 10 fingers out, another good day in the shop
10 fingers in, 10 fingers out, another good day in the shop