Randal: "Gary will handle the part of the presentation where he gets the rotary to sing, dance, and impersonate Elvis. <wink>"
Only if Elvis poked hornets nests with a stick
I doubt that, but.... How about a little VCPro "conversational" input to make one of these bolts? https://youtu.be/QPp1itlsbnI
Did you "rotary heads" know that VCPro will:
Allow you to mix indexed and wrapped cutting in the same job?
Allow you to rotate the rotary axis between multiple 2d toolpaths on indexed machining?
Allow you to do continuous rotary machining of a "spun" profile such as a hourglass or bat, etc.?
That you do not need a "Rotary Wrapped Setup" gadjet for anything? Or any of the rotary gadgets, for that matter?
That outta stir the pot