I am new to cnc and having a bit of a problem
I am trying to mill a small statue of nefertti
first attempt I used a vector boundry and when milling it gouged out a deep hole
I read on the forum make the model slightly larger than the work piece ( width ) this I done and then set the toolpath to model boundry
the roughing tool path looked ok
but when I then go on to do the finishing toolpath it starts in the wrong position
the only thing I change is the z height for the new tool
ps cant upload the file as it says file is to large
not doing as expected
-
- Posts: 15
- Joined: Fri May 20, 2016 4:03 pm
- Model of CNC Machine: marchant dice 8x4 4axis
- Location: swaffham norfolk uk
Re: not doing as expected
on the finishing toolpath I have deleted all the data from the center just leaving the start and end as it was to large to upload
any sugestions would realy be appreciated