Flem, there are a lot of good reviews over on Sawmill Creek about a system called Simple Hollowing System.
I am trying to hold the cost down a tad, some of those captured tool systems are pricey as all get out. They do not seem too bad until you add in about 3-4 of the actual tools.
Been using some of the Easy Tools to do the bowl work. They are pretty good because they are basically scrapers which is about the easiest way possible to turn. Of course, a lot of real turners scoff at scrapers because they do not produce that sliced finish. Myself? Sandpaper works good for me on lathe! Plus, I want to try some of that epoxy finishing using West Systems and then have a go at airbrushing. Another pricey little tool, sheeesh.
"If you see a good fight, get in it." Dr. Vernon Jones