Spiral Wrapping Problem
-
- Vectric Craftsman
- Posts: 208
- Joined: Sun Jan 26, 2014 12:59 pm
- Model of CNC Machine: CAMMaster Stinger II
- Location: Romney, WV
Spiral Wrapping Problem
Just installed my Rotary this week and testing it out, totally new to rotary. Tried to do a spiral path using the gadget. Pictures below show the tool path preview which looks like it is going to completely wrap the spiral but actual preview shows what looks to be only one revolution? When I calculated the toolpath, I thought the message box said there would be just over 3 revolutions. Any obvious set up error I'm making? Can get to the shop later to post the file if needed.
- IslaWW
- Vectric Wizard
- Posts: 1403
- Joined: Wed Nov 21, 2007 11:42 pm
- Model of CNC Machine: CNC Controller Upgrades
- Location: Bergland, MI, USA
Re: Spiral Wrapping Problem
Dave...
When doing spiral wrapping toolpaths that are more than 1 "wrap" the 3D preview will not show those portion beyond the first wrap as they are technically "off the model". Its not an error, just the way it is. As you show, the 3D wireframe shows the proper toolpath. Cut it! You can cut MUCH more than you can preview. Enjoy GC
If you really need to see the complete preview, there are a few tricks that will allow this, but you will have to wait til May!
When doing spiral wrapping toolpaths that are more than 1 "wrap" the 3D preview will not show those portion beyond the first wrap as they are technically "off the model". Its not an error, just the way it is. As you show, the 3D wireframe shows the proper toolpath. Cut it! You can cut MUCH more than you can preview. Enjoy GC
If you really need to see the complete preview, there are a few tricks that will allow this, but you will have to wait til May!
Gary Campbell
GCnC Control
ATC & Servo Controller Controller Upgrades
GCnC411 (at) gmail.com
GCnC Control
ATC & Servo Controller Controller Upgrades
GCnC411 (at) gmail.com
-
- Vectric Craftsman
- Posts: 208
- Joined: Sun Jan 26, 2014 12:59 pm
- Model of CNC Machine: CAMMaster Stinger II
- Location: Romney, WV
Re: Spiral Wrapping Problem
Ahhhh! After all the times I didn't pay attention to the preview and ruined the cut, this time I should ignore it, just kidding. Appreciate the info and will give it a try when I'm in the shop tomorrow. Thanks for the quick help.