Complete Newbie Need Help

Topics related to wrapped rotary machining in Aspire or VCarve Pro

Re: Complete Newbie Need Help

Postby Jeff Johnson » Sat Mar 19, 2016 5:56 pm

motor.PNG
Ok I found a better spec sheet for the motor. It is a 1.8 deg. So I still assume my calculations above are right?
Jeff Johnson
 
Posts: 48
Joined: Mon Apr 12, 2010 2:53 am

Re: Complete Newbie Need Help

Postby ger21 » Sat Mar 19, 2016 6:21 pm

Yes, 33.33333333
Gerry
ger21
Vectric Wizard
 
Posts: 862
Joined: Sun Sep 16, 2007 2:59 pm
Location: Shelby Township, MI, USA

Re: Complete Newbie Need Help

Postby Jeff Johnson » Sat Mar 19, 2016 11:46 pm

Thanks all who helped :D . I made a file of a 1" pvc pipe with small squares that wrap around the complete pipe, then chucked a piece in the jaw and scratched it with a 1/32 bit and it is correct. The toolpath where one square ended and another began were exact. I will post a picture of my first wood test piece next week sometime. I want to make a jig to hold the head and tail pieces that mounts to my spoil board. I wont have a chance to tinker no more till one evening next week :( . Busy busy!
Jeff Johnson
 
Posts: 48
Joined: Mon Apr 12, 2010 2:53 am

Previous

Return to Wrapped Rotary Machining

Who is online

Users browsing this forum: No registered users and 2 guests