I've recently done a major rebuild of my router and I needed to re-calibrate my rotary axis location.
Today I did a rotary job and found an issue, which is to do with my tool height setting I think.
To set my tool height (to the center of the axis), I use a machined brass post that sits on top of my tool height plate. This post plus plate height was level with my rotary axis center height, but that has obviously changed in the rebuild.
I machined up a project and found that my diameters were smaller than expected, so went looking for the reason.
I found that my height setter was in fact higher than the axis center line.
So my question is...
If I machine off some length from the brass post to lower it back to the center line again, will the same project file turn out larger or smaller than it did?
Or do I still have the possibility that I've missed something in my projects toolpaths?
I hope that makes sense.