Material Setup

Topics related to wrapped rotary machining in Aspire or VCarve Pro

Re: Material Setup

Postby garylmast » Sun Feb 07, 2016 5:53 pm

As near as I can tell, you're setting Z0 to the wrong place in Mach. In Aspire, you've specified that Z0 is the center of the part (which is generally the appropriate thing to do in rotary work). In Mach, you also have to set Z0 to the center of the part, not to anything related to the surface. Your note seems to indicate that you've set Z0 to something else, related to the diameter of the part. It needs to be set to the exact center (both in Z and in X) of your rotary axis.


As I mentioned, In Aspire, in the Wrapped Job Setup, the Center of the XY origin is chosen and the bottom of the Cylinder axis is chosen (which is really the middle of the cylinder being machined). Since you can't or don't want to drill a hole to the middle of the cylinder, the mill is placed on the top of the cylinder and half the material thickness is starting point (in the positive) and that number tells Mach 3 where the mill is. Also, I failed to mention, in the Material Setup, the Safe Z should be 1/2 the material thickness Plus an additional amount to clear the cylinder once the spindle retracts. The G-Code tells Mach 3 the diameter. Nothing else needs to be set.

Sometime I work in Aspire in inches, but my machine is setup in millimeters. When I save the post processor, Aspire will automatic convert it to the millimeter. If you notice the material setup is inches, however in Mach 3, it shows millimeters.
Attachments
Cylinder Orientation.jpg
mach 3.jpg
material setup.jpg
garylmast
Vectric Wizard
 
Posts: 571
Joined: Fri Oct 23, 2009 4:03 pm
Location: Sandy, Utah

Re: Material Setup

Postby TReischl » Mon Feb 08, 2016 3:26 pm

All good advice from Gary as usual.

Only thing I would "disagree" with is having to set the X0 to the middle of the part. I typically use the left end of the part.

Here is what my setup usually looks like:

Capture.JPG
http://www.tedreischl.com

Low Profile CNC Router Vise
User avatar
TReischl
Vectric Wizard
 
Posts: 1966
Joined: Thu Jan 18, 2007 6:04 pm
Location: Leland NC
Model of CNC Machine: 8020 Build 48X36X8 RP 2010 Screenset

Previous

Return to Wrapped Rotary Machining

Who is online

Users browsing this forum: No registered users and 1 guest