Pheasant panel
Moderator: Todd Bailey
-
- Vectric Wizard
- Posts: 1261
- Joined: Sun Jan 11, 2009 4:30 am
- Model of CNC Machine: 2014 roc-tech 4x8 with servos
- Location: bridgeton, indiana
Re: Pheasant panel
that is a very nice, well thought out design.
http://www.3dsigncamp.com
http://www.roctechusacnc.com
http://www.roctechusacnc.com
-
- Vectric Wizard
- Posts: 4797
- Joined: Thu May 18, 2006 3:24 pm
- Model of CNC Machine: ShopBot
- Location: North Carolina
Re: Pheasant panel
Very nice project Greg. Good choice for the wood and I like the edge treatment.
Tim
Tim
Re: Pheasant panel
Thanks for the kind remarks.
The outer edge I did with the modeling tools to give it the hand carved look as shown on James Booth's DC1 DVD.
The outer edge I did with the modeling tools to give it the hand carved look as shown on James Booth's DC1 DVD.
- JamesB
- Vectric Alumni
- Posts: 1257
- Joined: Tue May 30, 2006 1:24 pm
- Model of CNC Machine: Exel CNC SL60/90 Pro
- Location: Warwickshire, UK
Re: Pheasant panel
Excellent! I too like the outer edge and its good to see techniques shown for one application used in different places. Nice job.
Would it be OK to use an image of this on the website assuming that at some point in the future I get round to updating our gallery?
regards,
James
Would it be OK to use an image of this on the website assuming that at some point in the future I get round to updating our gallery?
regards,
James
Re: Pheasant panel
Yes James feel free to post the image on your gallery and thank you for the complement.
Greg
Greg