Horse Carriage Sign
Moderator: Todd Bailey
-
- Vectric Apprentice
- Posts: 55
- Joined: Sun Sep 07, 2008 12:19 am
- Model of CNC Machine: Camaster Stinger
- Location: Holt Florida
Horse Carriage Sign
Well here is my first western scene design. I actually did the palm tree first using the same design as the welcome sign. Ended up doing the Western Horse Carriage sign for my grandfather. One thing I will point out on the "Honeycutt" sign and it is hard to see here because I did try to fix it. If you look at the "n" you will see that it came in two separate pieces. Not a problem with this look however, the left hand side of the "n" where it looks like an r... the little part that comes off the right was way short from what it cut out in the inlay. I had to actually cut a small piece of wood and glue it onto the left part of the "n" Hard to really explain...
- RoutnAbout
- Vectric Wizard
- Posts: 2088
- Joined: Mon Sep 19, 2005 11:09 pm
- Model of CNC Machine: 24x18 Desktop
- Location: North Manchester, Indiana
Re: Horse Carriage Sign
Those look excellent. I like the way you've profiled them instead of leaving in a square blank.
And your right, I didn't notice the 2 piece "n". Nice recovery.
And your right, I didn't notice the 2 piece "n". Nice recovery.
-
- Vectric Wizard
- Posts: 862
- Joined: Wed Aug 16, 2006 7:34 pm
- Model of CNC Machine: shopbot 48x48 upgraded prt
- Location: Monessen, Pa
- Contact:
Re: Horse Carriage Sign
Nice ones, I didn't notice the "n" either but I know what you are saying, I'm doing a inlay on the corn hole game board and it did it in both the male and female section. I'll post when I'm done. Maybe this is something that vectric should look into. It only happen on this one piece and I went back and checked it and it was good on the screen.
Bob
Bob
- Penman
- Vectric Craftsman
- Posts: 146
- Joined: Wed Sep 10, 2008 10:58 am
- Model of CNC Machine: Shopbot B 32 Alpha
- Location: Blenheim. New Zealand
Re: Horse Carriage Sign
They came out very well and in my opinion look great.
Found the problem with the n, but only after you had pointed it out. Good
recovery though.
Roger.
Found the problem with the n, but only after you had pointed it out. Good
recovery though.
Roger.
Re: Horse Carriage Sign
Very nice job!! I also like the way you outlined the
signs.
Did you get the palm trees and western wagon from
Vector Art 3D?
Thanks
olf20 / Bob
signs.
Did you get the palm trees and western wagon from
Vector Art 3D?
Thanks
olf20 / Bob
Heat with corn, Mach3, Bridgeport clone, VcarvePo, Photo VCarve, Craftsman Wood Lathe, Arduino Toys
-
- Vectric Apprentice
- Posts: 55
- Joined: Sun Sep 07, 2008 12:19 am
- Model of CNC Machine: Camaster Stinger
- Location: Holt Florida
Re: Horse Carriage Sign
The palm trees came from the first Aspire disk I think...i am at work and can't check. The carriage came from the western disk...i really wish I had more time to do more.