Discussions and examples relating to the Design & Carve series for Aspire
I am just getting started at trying to cut a 3D image in wood.
I am using a CNC Shark PRO Plus.
I was curious as to what bits should I use for simple carvings. Can I use the Vcarve bits for the whole application?
Any suggestions or comments would be appreciated.
- Posts: 9
- Joined: Tue Mar 08, 2011 11:24 pm
For the 3d stuff I use 1/4 up cut for roughing,
1/8 and 1/16 ball nose for the finish work.
- Vectric Wizard
- Posts: 385
- Joined: Sat May 23, 2009 6:28 pm
- Location: AZ
Return to Design & Carve - Aspire
Who is online
Users browsing this forum: No registered users and 2 guests