This is a coat rack made from spruce 54x8 cut with one pass .75 deep at 3.33 inch a sec. took about 2hrs 50min.
Thanks, Greg
rustic coat rack
Moderator: Todd Bailey
-
- Vectric Apprentice
- Posts: 79
- Joined: Sat Dec 31, 2005 1:56 pm
- Location: Southern Arizona, USA
Re: rustic coat rack
Would it work better if it was not so close to the floor?
In all seriousness it looks great
Jeff E.
In all seriousness it looks great
Jeff E.
-
- Vectric Wizard
- Posts: 442
- Joined: Fri Jun 06, 2008 4:41 pm
Re: rustic coat rack
It's made for midgets. Looks very good job
- JamesB
- Vectric Alumni
- Posts: 1257
- Joined: Tue May 30, 2006 1:24 pm
- Model of CNC Machine: Exel CNC SL60/90 Pro
- Location: Warwickshire, UK
Re: rustic coat rack
Greg- very nice example. Would it be OK to use the image on our website?
Thanks,
James
Thanks,
James
Re: rustic coat rack
Ha Ha yes it is pretty low. Where I mounted it was in a vestible area wasnt enough room to take a picture after on the wall.
and yes James fell free to use image.
Thanks, Greg
and yes James fell free to use image.
Thanks, Greg
Re: rustic coat rack
That's some nice looking work. I like the way the grain of the wood flows across the bottom part of the carve.
John
John