help needed - software problem

Post Reply
elmariachi
Posts: 13
Joined: Mon Mar 30, 2009 11:29 am

help needed - software problem

Post by elmariachi »

Hi,

I`m using winpc-nc economy with heiz s-1000.

I made a fail in v-carve pro and exported it to winpc nc. The problem is that it cuts about 60% of real size and sets zero point different places everytime. Also does not read arcs, it puts cornes where should be arcs. With one word it is completely meshed up, doing nothing right. I have not had this kind of problem before.

What could be the possible problem for that? Is this a LPT port problem, soft or postprocessor?

cheers
Taniel

elmariachi
Posts: 13
Joined: Mon Mar 30, 2009 11:29 am

Re: help needed - software problem

Post by elmariachi »

Thanks for watching everyone,

Found problem. I had put a extra printer card and somehow it didn`t get along with integrated LPT anymore.Removed the extra LPT and it works now.

cheers
Taniel

Post Reply