highpockets wrote:Great getting to meet you Chris.
I'm in the "early" stages of replacing my Mach3 and control system with Centroid Acorn and a G540.
Just started today after getting home from the Vectric Conference.
ger21 wrote:A LOT of longtime Mach3 users have been switching to UCCNC. Very similar to Mach3, so super easy to learn. Very inexpensive as well.
Gerrry, it looks like a CNCdrive UC400ETH board will control 6 axes. Can I make that work with my Gecko G540, and then another single drive so I don't have to do the unplug/replug thing??
I recently learned of S-Curve acceleration Vs linear. Does UCCNC support S-Curve or something like that?
I definitely have more wires plugged into my Warp 9 smoothstepper board than the UC400ETH has places to plug in to... Would a UC400ETH replace my Warp 9 smoothstepper stuff, or would I need something else?
Users browsing this forum: No registered users and 1 guest