Hello,
I am currently experiencing an issue where upon pushing a movement command (x,y, or z) there is a delay of a second or two before it starts to move. It will stop upon releasing the key immediately without delay. On the monitor when I press the command to move, it shows the key being depressed instantly, so it seems it isnt a delay from the input of my keyboard. Has anyone experienced this problem before and if so, what did you do to remedy this?
Thanks,
James
Delayed response when issuing movement commands
- Rcnewcomb
- Vectric Archimage
- Posts: 5886
- Joined: Fri Nov 04, 2005 5:54 am
- Model of CNC Machine: 24x36 GCnC/WinCNC with ATC
- Location: San Jose, California, USA
- Contact:
Re: Delayed response when issuing movement commands
It may be a driver problem. Check for updates for your graphics card.
- Randall Newcomb
10 fingers in, 10 fingers out, another good day in the shop
10 fingers in, 10 fingers out, another good day in the shop
Re: Delayed response when issuing movement commands
I appreciate the response, it actually seems to be a networking issue. Upon disconnecting the ethernet cable the response time became immediate again.