My headaches continue with my AXYZ 4008 router. I am still struggling to solve my error 331 issue when running this file through DNC. So I thought I would save the vector out of aspire and then load it in AXYZ's toolpath software and see if I could get it to work from there. I am able to load the DXF into toolpath and get it to run on the router, but it is not showing the dog bone reliefs in the corners when loaded in toolpath. I'm not sure this is an issue on the aspire side I think it is possibly a problem with toolpath. I have been able to load the aspire dxf into other software/CATIA/Inventor and it loads fine with dog bones.
Has anyone else suffered with DXF issues when using toolpath software?